Gardner bender gdt-11 user manual


















Do not measure. Never measure AC voltage when the meter is set on DC voltage. Setting the meter on the incorrect function may burn out some of the internal circuitry and may pose a safety hazard.

When the voltage is not known, it. Do not store the meter in excessively hot,. This meter is a sensitive measuring device and should be treated with the same regard as other electrical and electronic devices. Do not pull the leads out of the jacks by the insulated wire or transport the tester using the test leads as a carrying strap. Do not immerse the meter in water or solvents.

To clean the housing use a damp cloth with a minimal. NOTE: With any measurement made by this meter, there will be some fluctuation of the digital display. This unit samples at a rate of 2 times per second, thus the fluctuation of the readout.

Read this operators manual thoroughly before using this multimeter. This manual is intended to provide basic information regarding this meter and to describe common test procedures which can be made with this unit. By: John Papiewski Updated April 12, Digital Multimeter image by TekinT from Fotolia. Share It. Plug the black test probe into the meter socket marked COM.

Tip Measurements of a 9-volt battery are safe as the voltage is too low to pose a shock hazard. The meter should measure roughly 9 volts. Book file PDF easily for everyone and every device.

You can download and read online Gb. You can download and read online Gdt. Tell us some more! Got it, continue to print. Not finding what you are looking for? Helpful 0 Not Helpful Flag. I have freestanding Series 8 dishwasher. Touch the test leads to the resistor or non-energized component to be measured.

Use the K range when testing. With resistance measurements, the polarity of the test leads is. Please replace the battery. Caution: When changing the battery, disconnect the test leads from the circuit completely. Remove the screws in the back cover of the tester and carefully separate the back cover from the front.

Remove the battery from the contacts, noting the polarity of the battery terminals and contacts. Replace with one fresh 9 volt battery. Note: Do not use rechargeable or lithium batteries in this unit. Carefully replace the back cover and tighten the screws. Do not overtighten the screws as this may strip the threads. Use botas o zapatos con. The desk features a total of 24 input channels, with 16 mono and 4 stereo input channels.

All mono inputs include XLR microphone inputs and inserts for routing signal to external processors. Follow all instructions and suggestions in this operators manual as well as observing normal electrical safety precautions. Do not use this meter if you are unfamiliar with electrical circuits and proper test procedures. Wear rubber soled boots or shoes.

Do not use test leads with broken or tattered insulation. Only test leads meeting. Never reset the. Do not measure. Never measure AC voltage when the meter is set on DC voltage. Setting the meter on the incorrect function may burn out some of the internal circuitry and may pose a safety hazard. When the voltage is not known, it.

Do not store the meter in excessively hot,. This meter is a sensitive measuring device and should be treated with the same regard as other electrical and electronic devices.



0コメント

  • 1000 / 1000